CET4快速阅读,挑战你的能力

　　you will have 15 minutes to go over the passage quickly and answer the questions on Answer Sheet 1. For questions 1-7,mark
　　Y (for YES)if the statement agrees with the information given in the passage;

　　N (for NO)if the statement contradicts the information given in the passage;

　　NG (for NOT GIVEN)if the information is not given in the passage.

　　For questions 8-10,complete the sentences with information given in the passage.

　　Theft deterrent system

　　To deter the vehicle theft, the system is designed to give an alarm and keep the engine from being started if any of the front, sliding and back doors and hood is forcibly unlocked or the battery terminal is disconnected and then reconnected when the vehicle is locked.

　　The alarm blows the horn intermittently and flashes the headlights, tail lights and other exterior lights. The engine cannot be started because the starter circuit will be cut.

　　SETTING THE SYSTEM

　　1. Turn the ignition key to the “LOCK” position and remove it.

　　2. Have all passengers get out of the vehicle.

　　3. Close and lock the front, sliding and back doors and hood.

　　The indicator light will come on when the front, sliding and back doors and hood are closed and locked.

　　As the front doors are locked, the system will give you a preparation time of 30 seconds before the setting, during which the front, sliding and back doors and hood may be opened to prepare for the setting.

　　Be careful not to use the key when opening either front door. This will cancel the system.

　　4. After making sure the indicator light starts flashing, you may leave the vehicle.

　　The system will automatically be set after the preparation time elapses. The indicator light will flash to show the system is set. If any of the front, sliding and back doors and hood is opened at that time, the setting is interrupted until it is closed and locked.

　　Never leave anyone in the vehicle when you set the system, because unlocking from the inside will activate (使起动) the system.

　　WHEN THE SYSTEM IS SET

　　Activating the system

　　The system will give the alarm and cut the starter circuit under the following conditions:

　　If any of the front, sliding and back doors and hood is unlocked without using the key

　　If the battery terminal is disconnected and then reconnected

　　After one minute, the alarm will automatically stop with the starter circuit cut kept on.

　　Reactivating the alarm

　　Once set, the system automatically resets the alarm each time the front, sliding and back doors and hood are closed after the alarm stops.

　　The alarm will be activated again under the following conditions:

　　If any of the front, sliding and back doors and hood is opened

　　If the battery terminal is disconnected and then reconnected