CET4快速阅读,挑战你的能力

    

　　Stopping the alarm

　　Turn the ignition key from the “LOCK” to “ACC” position. The alarm will be stopped with the starter circuit cut kept on. Stopping the alarm in this manner will keep the alarm from being reactivated when any of the front, sliding and back doors and hood is opened.

　　Interrupting the setting

　　With the system set, the back door can be opened with the key without activating or canceling the system. While it is open, the front and sliding doors and hood may be opened in addition, and the system can be activated only by the battery terminal disconnection.

　　To resume the setting, close and lock the front, sliding and back doors and hood. The back door must be closed with the key removed.

　　CANCELLING THE SYSTEM

　　Unlock either front door with the key, or unlock the sliding door with the key when it has been closed. This cancels the system completely and the starter circuit cut will be cancelled at once.

　　INDICATOR LIGHT

　　The indicator light gives the following three indications when the system is in use. When the light is:

　　FLASHING—The system is set. You need the key to open the front, sliding and back doors and hood.

　　ON—The system will automatically be set when the time comes. The front, sliding and back doors and hood may be opened without a key.

　　OFF—The system is inactive. You may open any door and hood.

　　TESTING THE SYSTEM

　　1. Open the driver’s and front passenger’s windows.

　　2. Set the system as described above. The front doors should be locked with the key. Be sure to wait until the indicator light starts flashing.

　　3. Unlock one of the front, sliding and back doors from the inside. The system should activate the alarm.

　　4. Cancel the system by unlocking either front door with the key.

　　5. Repeat this operation for the other doors and hood. When testing on the hood, also check that the system is activated when the battery terminal is disconnected and then reconnected.

　　If the system does not work properly, have it checked by your Toyota dealer.

　　1. The system is used to deter the vehicle theft according to the instructions.

　　2. In order to set the system, you should have all passengers get out of the vehicle.

　　3. The system will be cancelled when you use the key to open the back door.

　　4. The system will be not be activated unless you use the key to open any of the front, sliding and back doors and hood.

　　5. In order to stop the alarm, you have to turn the ignition key from the “ACC” to “LOCK” position.

　　6. When the indicator light is flashing, it is needless to use the key to open any of the doors and hood.

　　7. The passage tells us that the system works so effectively that it never breaks down.

　　8. As the front doors are locked, the theft deterrent system will give you a preparation time of before setting.

　　9. Before leaving the vehicle, make sure that the indicator light .

　　10. According to the passage, if the system refuses to work properly, have it checked by your .